Bosch Plena Voice Alarm Remote Control Kit

The kits are a functional match to the remote control and the RC extension, with connectors on the front panel instead of controls and indicators.

• Kit to create a remote control of the Voice Alarm Controller
• With emergency (EMG) microphone
• EMG state and fault indicators
• Control outputs for EMG and Fault state

All controls and indicators are available on screw terminals. The remote control kit has BGM zone selection without source selection, volume or tone control.

These kits make it easy to build a custom control unit. The electrical connections are printed on the front and rear panels. A 24 VDC output is available to supply power to external LEDs and relays, so an external power supply is not required for that purpose.

The remote control kit functions on an external 24 V power supply. The interconnecting CAT 5 (shielded) cable provides power for the RC extension and extension kit.

After connecting all indicators the following functions are available:

• The LED meter shows the presence and level of the calls that are running in the system

• The fault indicators show detailed information of a fault in the system

The connection to the Bosch Voice Alarm System is via standard, shielded CAT 5 cable and RJ45 connectors. The included rack mounting brackets can also be used to mount the units to a rear wall with spacing for cables, and even to a flat surface above or below the units.